Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

i2c standard and fast mode

Status
Not open for further replies.
B

balamani

Member level 1
Member level 1
Joined
Jan 11, 2013
Messages
38
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,554
Hi,


There are two modes in I2C interface. Standard mode (100KHz) and Fast mode (400KHz).

Let us assume a micro controller can support either of the modes.

How do we fix the mode (register setting or hardware pin configuration) ?
 

setting the SSPADD register for the microcontroller . using this formula..100kHz=Fosc/4*(SSPADD+1)
 

Through the microcontroller registers. Which MCU are you using?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top