Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How We Can Assemble A Epson Printer head

Status
Not open for further replies.

reza17

Junior Member level 3
Joined
Jun 18, 2006
Messages
25
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
1,425
repair print head lq-2180

hi
I Have A Problem With A Dot Matrix Epson Printer " LQ-2180"

Can You Help Me?
Are You Have An Instruction For Assebling PRINTER HEAD Of " LQ-2180 "
It Have Many Needle And Spring In It.
Thanks
 

reza17 said:
hi
I Have A Problem With A Dot Matrix Epson Printer " LQ-2180"

Can You Help Me?
Are You Have An Instruction For Assebling PRINTER HEAD Of " LQ-2180 "
It Have Many Needle And Spring In It.
Thanks
I was about to respond to your previous question about how to disassembly it with "Don't even try to do that".
Well, now is too late...
 

hi
it is not any instruction on do this

please help !!!!!!
 

reza17 said:
hi
it is not any instruction on do this

please help !!!!!!
Instruction is you should not have done that in the first place. And now, probably, the only thing you can do is send the printer to authorised EPSON service, or buy a new one. Good luck.
 

HI

I Dont Opened A Printhead

But I Want This Instruction For A Friend

I Want Only An Instruction To Opening And Closing A Printhead Of A Dot Matrix Printer " LQ-2180 "

An Step By Step Instruction .

Thanks
 

try to find in the service manual of the printer . take a look here **broken link removed**
 

Hi

Thanks , But I Dont Want The Printer Service Manual

I Want An Ster By Step Instruction For Opening And Closing The Head Of The Printer

Opening And Closing Printer Head Is A Hard Work.
 

first of all i want to know how he opened the head if he opened it by hitting the head from back side towards front side from its heat sink than i m afread he must have damaged the head and if he opned it by a proper press than its ok reply me did he fine any broken pins from the head or its all right just an opened only if than sure i can help u don worry just write me back the ecact status of the head
thnx
 

this is the service manual LQ-2180
**broken link removed**
for disassembly check on this service manual LQ-2170 page 84
**broken link removed**
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top