Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to vary light wavelenght electronically?

Status
Not open for further replies.

electronics_kumar

Advanced Member level 2
Advanced Member level 2
Joined
Nov 29, 2004
Messages
657
Helped
34
Reputation
68
Reaction score
9
Trophy points
1,298
Location
Tamilnadu
Activity points
5,552
Basically, semiconductor support light modulation(photo voltaic devices) and conductivity modulation(diode,transisitor)
output wavelength of any light signal coming out of semiconductor depends upon its bandgap..in the process of light modulation.so. you try to vary bandgap of the semiconductor which will ultimately vary it's output wavelength ..The basic relationship of a photon's Energy to it's frequency is E=hf where E is the photon's energy in Joules, h is Planck's constant, and f is the photon's frequency.
E=h/λ....h=planck constant...HOPE IT HELPS....
REPLY ME THE OBJECTIONS IF ANY
 

brahma

Advanced Member level 4
Full Member level 1
Joined
Sep 29, 2005
Messages
109
Helped
15
Reputation
30
Reaction score
1
Trophy points
1,298
Activity points
2,191
electronics kumar you have written E= h/λ. But by quantum theory E = hf,
where f - frequency. Then velocity of light could be written as c = fλ, therefore wavelength is

λ = hc/E = 1.24 / E ( µm )

c - velecity of light =3×10^8
E - bandgap energy
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top