When I use hspice to verify my circuit that I have calculate to decide voltage & current. But sometimes the mos doesn't in Saturati region, maybe in linear or tirode.
After simulate the circuit by hspice, Output listing (.lis) will show some results form the analysis of the circuit , how to use the Output listing (.lis) to modify some mos to reach Saturati region & the circuit is match the SPEC.
This will print the DC operating point of your circuit. First check that the voltages on the nodes in your circuit are what you intended them to be. Next check if the
current flowing through your circuit is what you intended.
After that, you can use various sweeps to store more data and plot things
using Awaves or Spice Explorer.
Here is a simple tutorial on how to plot things: **broken link removed**
When you use the .OP Statement, the listing file (.lis) will contain the operating point information of your circuit, telling you the voltage at different nodes and the state in which the transistor is in.
This information helps you to modify the circuit or in the transistor resizing to obtain them in Saturation state.
I have used .op in my netlist, then some mos don't in Saturati region.
I try to modify these mos size, but they still not in Saturati region.
When I design the circuit, the vds doesn't I want when I calculate the Id current,
so I think this is a result that the mos can't into Saturati region .
Is it right ?