Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to use dsp to interface a CAN controller?

Status
Not open for further replies.
J

Jerry_chan

Guest
I want to use TMS32054x DSP to control a CAN controller.
Most CAN controllers' parallel interface is multiplexed.But TMS32054x DSP is non-multiplexed.So how can I design the interface between them?And is there any CAN controller that has a non-mutiplexed parallel interface?
Thank you very much!
 

what about microchips mcp 2510 via SPI....

good luck

curgi
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top