arun thiagarajan
Newbie level 1
hi to everyone i had a problem in using band pass filter in simulink for selecting the particular if frequency.if you had an answer pls post a solution it`s a very urgent......
Welcome to EDAboard.com
Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how to use band pass filter in simulink
- Thread starter arun thiagarajan
- Start date
- Status
shreyas_patel21
Full Member level 3
you can use LC network or two RC networks
or can elaborate ur need in more detail
or can elaborate ur need in more detail
- Status
