how to use adc7..6 in ATmega8 (TQFP)

Status
Not open for further replies.
C

canarybird33

Member level 1
Joined
Apr 16, 2013
Messages
41
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Location
Mashhad, Iran, Iran
Activity points
1,591
Hi
there is any special rule to use the adc[7..6] of At-mega8?
Actually when I try to use this 2 extra pins, At-mega8 is getting hot and don't works properly.

 

You cannot violate the MAX Voltage specification on the pins - what is the voltage of the power rails o the op amp you are using, and what is the output voltage? You must make sure that you keep the voltage between GND o the ATMEga and no more than 0.5V above Vcc of the ATMEga to avoid damage. Also, for the A/D conversion to work properly, you must keep the analog voltage value between GND and the Vref voltage level to the ATMEga.
 

thanks for replay
I have considered every things you said.(MAX output voltage of opamp is 4.96).

I have used all ADCs of ATMEGA8; there is no problem when using adc[5..0] but ATMEGA doesn't work properly and gets hot when connecting the same circuit to adc 7 and adc68-O

what I'm suppose to do?:thinker:
 

What package version of the chip are you using, the QFN, or the TQFP package (there is no ADC7 or ADC6 on the PDIP version)?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…