Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to use a wave from oscilloscope in multisim or proteus isis?

Status
Not open for further replies.

alexst

Newbie level 2
Joined
May 25, 2011
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
How to use a signal from oscilloscope in multisim or proteus isis?

Hi,
I got a wave from oscilloscope in a csv extension, this is a real wave, now I would like to simulate in multisim or proteus isis this wave instead of the common models of wave like sine or pulse.
does someone know do it?
 
Last edited:

john blue

Advanced Member level 3
Joined
Jun 7, 2007
Messages
821
Helped
213
Reputation
430
Reaction score
204
Trophy points
1,323
Activity points
4,749
Hi,

can you explain more?
 

alexst

Newbie level 2
Joined
May 25, 2011
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
Re: How to use a signal from oscilloscope in multisim or proteus isis?

Hi,
I acquired a signal by a oscilloscope, my oscilloscope saved this signal in a CSV file, then I would like to put this signal in a simulation software like Multisim or Proteus Isis, because I'm trying to build a filter and it would be better to use a real signal instead of a signal like sine or pulse, this real signal is from a sensor.
 

john blue

Advanced Member level 3
Joined
Jun 7, 2007
Messages
821
Helped
213
Reputation
430
Reaction score
204
Trophy points
1,323
Activity points
4,749
most likely you cant. You can try Labview for that.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top