simulate the design by importing into ads layout
During import, layer automap is showing the different layer names for mapping, After import, I can see the imported layout
and I changed the layer to my original layer which I drawn design (cond).
but there I am unable to give ports to that ?
I am unable to assign ports
I dont know the reason and even when I simulate that I am not getting the same results as compared to the original design...
while generating the GDSII file for layout whether it contains any port information like cadence???
the first image will show my original ads layout
and for this Iayout1.png I created gdsii file then I imported in new layout
if you observe both the first image I gave pins and in gdsii genrated layout i am unable to give ports eventhough the port and layout are in same layers (cond)...in the second image you can observe like the port is not connected. why?
Suppose I have one JPEG file and I am converting that JPEG file to GDSII then this GDSII file I will directly import in ADS layout and here I will give ports and I will simulate (instead of designing in layout ) this will save my lot of time,
I attached the image of gdsii layer layout that both metal and port are on same plane cond. Now, my questions are
1. " Even though metal and pin are in same plane why Pin is showing as not connected ? "
2. " Can we assign pin to Imported GDSII layout ,I know that we can import GDSII file but my doubt is whether can we simulate it ? "
For example take Cadence tool (CMOS Designing tool) in this if you generate GDSII file for layout that GDSII file also contains Ports information in this case even if you import the GDSII file it will be simulated there is no need to assign pins again to gdsii layout it already contains that.
run EM Simulation in ADS through coding ?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?