Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to setup my beagle board output to LCD using HDMI

Status
Not open for further replies.
navenmou

navenmou

Full Member level 4
Joined
Sep 25, 2010
Messages
228
Helped
49
Reputation
98
Reaction score
46
Trophy points
1,318
Location
Bangalore, India
Activity points
2,588
Hi All,

I'm working on QNX Neutrino. I built QNX BSP OS image on TI OMAP 3530 Beagle board. Now i want to connect my beagle board output to LCD monitor using HDMI cable. I've done that work also. But my LCD not displaying anything in HDMI mode. And Every time LCD displaying message, i.e "Mode Not Supported".

If any have idea regarding this please suggest your solutions.

Regards
N@ven
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top