Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to set up port definition - grounded CPW in Ansoft HFSS?

Status
Not open for further replies.

joechien0218

Newbie level 1
Joined
Feb 10, 2006
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,290
Hi,

Hope someone out there can kindly help on this topic.

How to set up port definition for grounded CPW in Ansoft HFSS? If you have a screenshot, do you mind sending to me? joechien0218@yahoo.com

Specifically, I'm wondering where the excitation vector should be placed. For NON-grounded CPW, I know that the excitation vector points from the ground plane to the center conductor. But when the bottom side ground is present, I'm confused as to where this vector should be placed at.

Also, how big should the waveport be in general? Is there a general rule of thumb?

Thanks for your help guys! Please email me if you have something to share.
Joe
 

abeeshktr

Newbie level 2
Joined
Jan 19, 2011
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
i am abeesh, doing project in ansoft (cpw design ) in my design i got vswr 20000 etc...
anyone know the reason for that .......i had given two lumbed ports ... at the front side and back side ....
reply to my email id abeeshktr@gmail.com
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top