I am learning how to design a charge pump and have read a lot of papers. Only theories are discussed in these papers. No one talks about how to set the parameters: W and L of transistors, f, capacitors and so on. Does anybody have some materials about this kind of information?
Same here, I have not seen an explicit formulas, I believe it's because I did not dive deep in the subject. Try to look at this book, Charge Pump IC Design by Feng Pan, it may help. Also, you may drive them it should be straightforward.
These parameters depend on your voltage level. For example, if you are using close to 1V, W/L has no big difference, You may try use minimum one. f and capacitor values need to be chosen to ensure charge transfer and minimum/acceptable capacitor level.