Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to select appropriate ohm/square to achieve 100 Ohms?

Status
Not open for further replies.

sviodo

Member level 4
Member level 4
Joined
Jan 2, 2002
Messages
68
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
533
resistor 0603

I need S matrix of 100 Ohm thin film resistor. Would be great if s2p file covers bandwidth of 6-20GHz, but i'll be greatful for anything :>
anyway i've tried to simulate response in sonnet. However i don't know how to select appropriate ohm/square to achieve 100Ohms :< So if you have simulated results in sonnet/hfss or other fullwave simulator and you would like to help plz send me results.
 

resistor 0603

Usually the vendor provide 100 ohm/square or 50 ohm/square thin film resistors. 50 ohm is more common than the 100 ohm. If you use 50 ohm, then you will need a ratio of length to width 2 to get the one hundred ohm. This is based on the simple DC calsulation. Actuall performance also relies on distributed effects. It, however, depends on the size of the resistor. If the size is ver small, then you can mimimize the distributed circuit effects. Both MWO and ADS have good model for this. and you do not have to use 3D solver.

Linda.
 

Thanks for your reply, however this is like 6 months old post and i found a solution :)
You are right that ads has built in models that you can use. The problem is that you can't trust accuracy at 20GHz that's why i needed fullem simulation or measured results.
Anyway thanks for help budy,
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top