How to see the connections in Altium PCI card template?

[buenos]

hi.

my problem:
i always used the PCB wizard to start a pcb project.
but now, i want to design a PCI card from a template, and i realized a strange thing:
when i put the components onto the board (design > import chan...) then the connections are not visible. probably its switched off in the template project.

where can I switch it back on?

 

[Siniša]

Re: altium connections

It's most likely that you did not import netlist.

 

[buenos]

@ltium connections

there is the netlist, because i can see the assigned nets on the pins on the pcb. if i open the netlist editor, i also can see all the nets.

 

[House_Cat]

Re: altium connections

The net connection lines will be invisible if the PCB panel is set to From-To Editor. After editing From-To's, if you shut down the software with From-Tos in view and then restart, you will not see the connections.

Once you finish using the From-To Editor, simply change the PCB panel to one of the other drop down options and the connection lines will reappear.

The view setting is written in the registry, so it is not cleared by uninstalling and reinstalling the software.

Also take a look at the suggestions at:

**broken link removed**

 

[buenos]

@ltium connections

thanx, but finally i have found it:
pcb layers and colors>conn and freomto>on