Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] How to prevent the physconfig from automatically opening when opening a layout with Virtuoso Layout XL?

Status
Not open for further replies.

BrownieHaHa

Newbie level 6
Newbie level 6
Joined
Aug 2, 2024
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
122
I have a small question to ask everyone (although it's a small issue, it's a bit OCD-inducing and also affects work efficiency):
Every time I open a layout with Virtuoso Layout XL, if there is a schematic, it automatically pops up the physconfig window, as shown in Figure 1;
1727274178627.png

If there is no schematic, it defaults to popping up an "update connectivity" window (which is also quite annoying), as shown in Figure 2; if I click yes, it reports an error; if I click no, it reports *WARNING* (LX-2040): Cannot open cellview in Layout XL because there is no connectivity reference defined. The cellview was opened in Layout L instead.
1727274193961.png

I've searched cdshelp and looked through some user guides, but haven't found a solution. I would like to ask how I could configure cdsinit to address this?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top