A_Graham
Newbie level 3
hspice waveview processing command
I'm using Hspice and to plot the operating points using WaveView of a mos, having done a DC sweep of the Vgs. I know that if I use
.option post
then the command
plot dc lx7(xmnt2.xmn)
should work to plot the gm. So in the output.lis file, I see something that looks like an ASCII plot, but I need to plot it in WaveView, and its not available there in any of the files, even though I used .option post.
Added after 14 minutes:
Sorry, just copped it!
I needed to put gm= in front of the lx7 statement like this:
.plot dc gm=lx7(xmnt2.xmn)
I'm using Hspice and to plot the operating points using WaveView of a mos, having done a DC sweep of the Vgs. I know that if I use
.option post
then the command
plot dc lx7(xmnt2.xmn)
should work to plot the gm. So in the output.lis file, I see something that looks like an ASCII plot, but I need to plot it in WaveView, and its not available there in any of the files, even though I used .option post.
Added after 14 minutes:
Sorry, just copped it!
I needed to put gm= in front of the lx7 statement like this:
.plot dc gm=lx7(xmnt2.xmn)