Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to move components without changing routing in altium

Status
Not open for further replies.

hithesh123

Full Member level 6
Full Member level 6
Joined
Nov 21, 2009
Messages
324
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Location
lax
Activity points
3,548
How do i move components in altium without rerouting.
I want the traces to be connected while I move the components.
Is this possible?
 

As far as I know this is only possible in the older versions. 09 and 10 do not have that option anymore.
I have never used this options, since it was not working very well. Always had to go back and clean it up.
 

How do you make it work in the older versions?
 

There is an option somewhere in the PCB preferences called 'component drag'.
 

Well. I couldn't find component drag.

Do you know how to add board outline?
Which layer should I use to draw the outline - Mech1?
 

The option is under Preferences >> PCB Editor >> General. You will find it under "Other" 4th option drop down box, called Comp Drag
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top