Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to minimize loses through multilayer RF Stack up

Status
Not open for further replies.

berms03

Newbie level 1
Joined
Nov 4, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Multilayer RF Stack up

So I'm trying to route an RF device, but do the complexity of the device, I can't route the RF on a single layer. I know routing RF on separate layers will loose a little bit of performance, but at this point it's my only option. Will the following stack up minimize the lost?

RF SIGNAL
GND
SIG1
SIG2
GND
RF SIGNAL

Would it be better to go with an eight layer board?
 

Yes. The above approach is ok. Just take care that Sig1 and 2 are separated greater extent such that there is no or minimal cross talk.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top