Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to measure the Scattering parameters of an RF front end integrated in the circuit

Status
Not open for further replies.

aangles

Newbie level 5
Newbie level 5
Joined
Feb 10, 2011
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,349
Hello,

I would like to know how we can measure the scattering parameters (S11, S21, S22, S12) of CC1190 Texas Instruments RF front end which is integrated on our circuits and we only have one connector: the antenna connector at the output of the CC1190 matching network. We have one connector at the output. Then we would need something (such an RF coaxial soldered at the input of CC1190 and by using a vector network analyzer we could get the scattering parameters but I don't know where to sold that RF coaxial cable).

I know it exists RF probe but I am not sure and I don't know how to use them.

Thank you very much
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top