Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] How to measure OPAMP DC Gain

Status
Not open for further replies.

movinghoon96

Junior Member level 3
Junior Member level 3
Joined
Jan 27, 2023
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
215
Hello, I want to measure DC Gain for general 2-stage opamp.

It is showing something like hysteresis, 106mV for Input : Low->High, 58mV for Input : High -> Low

So adding 1 mV Source to input was not successful.

Also, I tried following link

but simulation failed, it said need more strict time interval.



I think offset can be compensated by adding voltage source, but what can i do for hysteresis?
 

Hi @movinghoon96 ,
Please, provide your schematic and simulation setup, it's very hard to understand what is the problem exactly.
In general, DC gain can be measured by using ac/stb analysis in ADEL.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top