How to Make Software Defined Radio using Cyclone III EP3C120F780 Development Board

[sntsh]

Hello everyone I am new in EDABOARD Forum.
I am trying to make a Software Defined Radio using Cyclone III EP3C120F780 FPGA development board. Can anybody give some idea about my project.

Thanks in advance...................//

 

[bluehole]

have you seen this **broken link removed**

Hope this will give you a start.

 

[sntsh]

Thanks.

But firstly I want to know, Will the development board work like SDR?

 

[bluehole]

Well, I have not done the project as the cost doesn't permit me for it:lol:

then If i am allowed to guess then you can implement the same functionality on your FPGA, as they have implemented.

Now the board is the controller the TX and RX modules are separate add on boards.
hence you may require them too.

By the way if the size of your FPGA is same as the FPGA used then you may not face any problem. It is a guess though.

you may be interested in elektor SDR.

 

[sntsh]

Hello bluehole, I had seen elektor SDR but this is only receiver.
I want to make the cyclone III development board as transceiver.

I have searched the net very much but can't find programme for SDR.

 

[bluehole]

Hello bluehole, I had seen elektor SDR but this is only receiver.
I want to make the cyclone III development board as transceiver.

I have searched the net very much but can't find programme for SDR.

then your only alternative is USRP