for checking in hyper terminal u don't need to program GPS just connect the Tx pin of your GPS module and V cc, ground to the above mentioned DB 9 connector to your PC and view in Hyper terminal
You will received data.. It will repeat for every 30 sec
So disconnect after a minute or so.
Then check what are you getting
$GPGSV,2,1,08,01,40,083,46,02,17,308,41,12,07,344,39,14,22,228,45*75
$GPGSA,A,3,04,05,,09,12,,,24,,,,,2.5,1.3,2.1*39
$GPGGA Global positioning system fixed data
$GPGLL Geographic position - latitude / longitude
$GPGSA GNSS DOP and active satellites
$GPGSV GNSS satellites in view
$GPRMC Recommended minimum specific GNSS data
$GPVTG Course over ground and ground speed
So read the manual for NMEA Protocol
Consider any for Eg if you consider $GPGGA and its value...
it will give you position and time
you can display it through Programming on LCD