Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to install linux kernel image on ARM through jtag

Status
Not open for further replies.
D

dave1987

Newbie level 5
Joined
Jul 13, 2009
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
mumbai
Activity points
1,334
hello, i want to burn kernel and filesystem images on my ARM 10 controller
using JTAG
can anyone help me with commands???/
I used the command ./Jflash-innovate-boot for burning bootloader and it was successfull but the it doesn't show any prompt on minicom.
 

Can you burn the kernel using the bootloader to the flash memory?
You will tftp the kernel to a memory place in ram, then copy it to your flash instead of using JTAG.
--
Amr Ali
 

The problem is that the bootloader is already burned successfully but when i connect it using serial port it does not show any prompt on minicom.

my kit is ARM 1020tdmi PXA255 INNOVATE
 

Did you set the minicom correctly?
--
Amr Ali
 

I feel that bootloader is not the correct one. Even i have the same problem. I was given the wrong bootloader. How much did you pay for Jflash programmer. Please contact me on nic_b20042003@yahoo.co.in


Nitin
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top