Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to give output as only one input to block in Matlab?

Status
Not open for further replies.

rednewguy

Full Member level 2
Joined
Jun 3, 2005
Messages
123
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Activity points
2,413
matlab - output branch

in simulink after some blocks i get some output, which i have to give as input to two or more blocks. but i could take only one; what can i do? suggest me.
 

boeysue

Full Member level 3
Joined
Dec 23, 2004
Messages
188
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,296
Activity points
1,523
Re: matlab - output branch

You can use the "Shift" key and then grasp the output line of the block,and then you can get the copy output line of the block.
 

    rednewguy

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top