Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to find the correct polarity of 6 wire stepper motor to interface with pic16f877a

Status
Not open for further replies.

rangerskm

Full Member level 4
Joined
Jan 23, 2013
Messages
199
Helped
0
Reputation
2
Reaction score
0
Trophy points
1,296
Activity points
2,663
1) i am trying to connect my stepper motor to pic but i dont know the polarity of that.its 6 wires

above 3 wires-black ,red ,brown

below 3 wires-orange red yellow.,

does this means anything ..

the vendor is NMB from thailand.
its model no-PM42S -048-ZTH8
 
Last edited:

anboli

Full Member level 2
Joined
Mar 9, 2012
Messages
144
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,298
Activity points
2,512
1) i am trying to connect my stepper motor to pic but i dont know the polarity of that.its 6 wires

above 3 wires-black ,red ,brown

below 3 wires-orange red yellow.,

does this means anything ..

the vendor is NMB from thailand.
its model no-PM42S -048-ZTH8


hi,

basically the stepper motor needs four combination of wire to drive the motor in CW and CCW. from the above mentioned colour Red is given to Vcc, and remaining 4 colors clearly mentioned in their datasheets..
 

Attachments

  • steppermotor.bmp
    1.2 MB · Views: 4
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top