Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to draw diagonal wire in ADS schematic design?

Status
Not open for further replies.

tsinghua

Full Member level 4
Joined
Dec 30, 2003
Messages
222
Helped
23
Reputation
46
Reaction score
3
Trophy points
1,298
Activity points
1,111
ads schematic

To make the schematic look better, I want to draw diagonal wires in ADS.
Is it possible to do this in ADS? If so, please show me how to do it?
Thanks!
 

prakashrtvm

Junior Member level 1
Joined
Jan 9, 2007
Messages
17
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Activity points
1,425
cadence draw diagonal

Hi Iam not familiar with ADS, but usually in the CAD packages there will be a setting to allow or not allow orthogonal lines.

If you permit orthogonal, then diagonal lines will be possible. Hope ADS will also have some similar setting...
 

tsinghua

Full Member level 4
Joined
Dec 30, 2003
Messages
222
Helped
23
Reputation
46
Reaction score
3
Trophy points
1,298
Activity points
1,111
Thanks for the reply.
Actually I tried and did not find this kind of settings in ADS. So I use cadence composer to draw schematic and to run simulation through ADS dynamic link.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top