Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to do PCB EMI/EMC simulation using CST Microwave?

Status
Not open for further replies.

Bibhu166

Newbie level 5
Joined
Feb 7, 2007
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,333
Hi All,
Can any one plz guide me how to conduct PCB EMI/EMC simulatyion using CST Microwave studio.I too need some basics o EMI/EMC of PCB simulation.
Regards,
Bibhu
 

mpero

Member level 1
Joined
Feb 9, 2006
Messages
38
Helped
14
Reputation
28
Reaction score
10
Trophy points
1,288
Activity points
1,564
Re: Hi

Bibhu

take a look here

https://www.cst.com/Content/Applications/Category/Signal+Integrity+and+Power+Integrity

basically this PCB simulation is challenging, due to the extreme complexity of the boards and all (connectors, vias, etc). You got to get the board imported into CST MWS by means of a CAD format (Gerber, DXF, etc). Then assign the ports, etc.

As a guideline, frequency domain solver for multi-port boards, time domain for huge structures and when an arbitrary input signal is needed (like rectangular pulses).

I hope it helps!
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top