Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to do membrane switch PCB Design

Status
Not open for further replies.

satiahg

Newbie level 6
Joined
Oct 18, 2011
Messages
11
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
india
Activity points
1,351
Hello,
Can any one please tell about membrane PCB Design,now i am designing a remote in that we are using membrane switches.
 

what system are you using?

In CADSTAR I would do this by drawing 2 interleaving fork/finger shaped copper shapes and adding a small surface pad on each so I can connect to them, then add a solder resist shape that give clearance for them all.
Also adding a shape on a layer that I would use for carbon coating.
 
Hi mattylab thanks a lot for the replay here i am using cadence_allegro can you please tell how to do it on this.please provide if you have any guidlines or weblink for regarding this.
 

Hi satiahg,
when you have any problems with PCB i recommend the of EAGLE.

greetings, Francis
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top