eagle1109
Full Member level 6
- Joined
- Nov 20, 2014
- Messages
- 390
- Helped
- 4
- Reputation
- 10
- Reaction score
- 7
- Trophy points
- 1,298
- Location
- Saudi Arabia
- Activity points
- 5,929
Hi,
I want to develop a d-pad module in proteus, I know how to design the sub-circuit for the module in the child-sheet for the module outputs but I don't know how to program the buttons of the UI of the module, I think there are 2 ways of programming those buttons:
1. Write the commands for those buttons in the device properties:
I don't know how to understand those coordinates.
I know that
that square is the square shape of the module, but I don't know how to interpret those numbers.
2. Develop a sub-circuit in the child-sheet:
As in the picture I know that the outputs of the child-sheet design are connected to the same ones on the schematic-sheet but I want to connect the push buttons of the child-sheet to the green ones on the schematic-sheet.
I want to develop a d-pad module in proteus, I know how to design the sub-circuit for the module in the child-sheet for the module outputs but I don't know how to program the buttons of the UI of the module, I think there are 2 ways of programming those buttons:
1. Write the commands for those buttons in the device properties:
I don't know how to understand those coordinates.
I know that
Code:
{A1=SQUARE,0300,-300,300}2. Develop a sub-circuit in the child-sheet:
As in the picture I know that the outputs of the child-sheet design are connected to the same ones on the schematic-sheet but I want to connect the push buttons of the child-sheet to the green ones on the schematic-sheet.