Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to design the rigid flex PCB in Altium

Status
Not open for further replies.

rajn

Newbie level 1
Joined
Apr 12, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Hi,
I am new to the rigid flex PCB design. I need to design a rigid flex PCB with some components on the rigid side and a ZIF connector on the other side of the flex. I need to have a 2 layer PCB. Is this signal stack-up good?

Top Layer
Flex-Layer 1
Flex Layer 2
Bottom Layer

Without any internal plane.

or in other terms, how can I design a 2 layer rigid flex PCB in Altium?


Thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top