Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You cannot do a direct conversion of a layout from Pr0tel to C@dence.
The best you could do would be to export the netlist from Pr0tel, then use that netlist in Allegr0 or 0rcad. There are several different netlisters available on the @ltium website. See: https://www.altium.com/Community/Support/Downloads/ and look under "Additional Output Generators".
You could also output a .DSN file that can be used by C@dence layout software.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.