Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to control EEPROM simulator via network?

Status
Not open for further replies.

astra

Junior Member level 1
Junior Member level 1
Joined
Jul 16, 2002
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
45
I want to connnet EEPROM simulator to ethernet network end controll it.
How to make it? Any suggestions (based on practical design) ?

Best regards to all forum members
 

ash

Full Member level 3
Full Member level 3
Joined
Dec 25, 2002
Messages
151
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,298
Location
Europe
Activity points
1,051
I think, first, you shuld build a ethernet interface card. Then send the signals to interface mcu and comminucate mcu with eeprom. That's all.

Best regards
Ash
 

stevenyouth

Member level 1
Member level 1
Joined
Sep 8, 2001
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
143
You can use RTL8139 ethernet chip , it is easy to find(made in Taiwan)read the datasheet about the control.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top