Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to connect PowerPC440 with ICAP

Thread starter lahrach
Start date Apr 10, 2011

Status: Not open for further replies.

Apr 10, 2011

#1

L

lahrach

Full Member level 3

Hi friends,
I need to connect ICAP with the PPC440in Virtex-5 FPGA, is it via XPS or SDK or ISE

Any sugetion wil be very helpful

Best regards,

Apr 15, 2011

#2

A

aethor

Newbie level 6

In XPS look at the IP catalog, there should be a peripheral called 'hwicap'. That's the one you need.

Status: Not open for further replies.

Similar threads

T
Connect Microblaze to AXI4-Lite
- Started by trungnd33
- Mar 23, 2023
- Replies: 3
PLD, SPLD, GAL, CPLD, FPGA Design
K
explanation of how to translate C code into verilog
- Started by keikaku
- Mar 5, 2024
- Replies: 10
PLD, SPLD, GAL, CPLD, FPGA Design
M
How to connect AXI_LITE port of QSPI_FLASH to the RISC-V processor.
- Started by michaelScott
- Dec 31, 2022
- Replies: 0
PLD, SPLD, GAL, CPLD, FPGA Design
A
How can I run verilog code with data at a specific time in the past?
- Started by alexis57
- Jan 28, 2024
- Replies: 2
PLD, SPLD, GAL, CPLD, FPGA Design
A
Direct connection of FPGA (spartan-6) to HDMI connector
- Started by aminpix
- Jan 3, 2024
- Replies: 3
PLD, SPLD, GAL, CPLD, FPGA Design

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn more…

Top