Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to configure the LINUX files and start the ASITIC?

Status
Not open for further replies.

fzhaou2006

Newbie level 3
Joined
May 12, 2006
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,303
asitic_linux start

Hello,I am a new to asitic.I have read the Installation document of ASITIC,but I still can't startup the ASITIC.How to configure the LINUX files and which command should I use to start the ASITIC?Thanks.
 

hrkhari

Full Member level 4
Joined
Mar 4, 2004
Messages
224
Helped
6
Reputation
12
Reaction score
3
Trophy points
1,298
Activity points
2,250
Re: start asitic

Hi:

I don't any difficulity in installing ASITIC on Linux, just un-tar the downloaded grackle version and set the path in the .cshrc file. Hope this helps

Rgds
 

fzhaou2006

Newbie level 3
Joined
May 12, 2006
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,303
start asitic

thanks,I solved my problems in installing ASITIC on Fedora core.The command"./asitic_linux" can start the software.

Added after 3 minutes:

But I have another question.whether ASITIC support 6-layer metal simulation and how to get information for techfiles?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top