lvds galvanic isolation
Hi kobik,
Again: normally you do not use a transformer on LVDS line, even if it's
possible (in some circumstances). So if you don't have a big reason
(common mode problems, using coax-cables) you should use a direct
coupled LVDS.
In the case of such low bitrates as you wrote (below 100MBit/s) I think you
could try it with an 100MBit Ethernet transformer. The missmatch in
termination won't be very critical.
For further information look at the national homepage, they have a lot
of design rules for LVDS lines.
Bye