How to change page size when creating a footprint in Allegro PCB editor

[hopking]

Hi, I got a problem when creating a footprint symbol for a 64pin connector using Allegro PCB editor 16.3.
The default page size is about 800*800mil, but my connector is 36mm*6mm, which far exceeds the page size.
I tried but still can't figure out how to change the page size. Anyone can tell me how to do this? Thank you!

 

[sapphire_2010]

hi
check this , go to setup--> design parameteres-->design tab and increase page width and size here
SA

 

[hopking]

hi
check this , go to setup--> design parameteres-->design tab and increase page width and size here
SA

Thank you so much