Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Whether it is serial or parallel link, if serial then your clock frequecny should be 1 Mhz else 1Mhz/bus_width, It depends also on the block designer to use what frequency.
Well, frequency at which your block is working can by anything really, Mpbs cannot really tell it. Depends upon your architecture:
Kr,
Avi http://www.vlsiip.com
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.