Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to and what are the rules and ways create the foot prints?

Status
Not open for further replies.

akrishna71@gmail.com

Junior Member level 3
Joined
Oct 8, 2012
Messages
28
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
CHENNAI,INDIA
Activity points
1,496
hi seniors,
i have doubt create the foot prints in orcad ,

i created one project and in which one 15 pin connector there. for that i just wanna create foot print ,but everytime i am getting error like pin 1 is missing

pin 2 is missing likewise all pins .

i had used that orcad pcb designer software in which used package symbol wizard .

add-lines , drawn the rectangle in sub.class : Assembly top

then layout-pins i have taken the pad35cir21d this padstack.

placed the 15 pins ,

then add- line- drawn full covered rectangle by sub.class: silkscreen top

and then layout - Refdes -U** ,.,...,.,..,...,.,?????? my guess is correct means i have error mistake at this place

when i was save the page it shows refdes error and warning ,,.,.






so please help dears, i need a help from you.

tell me what are ways or steps to create the foot prints ? tell me...
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top