How to alleviate the effect of slew rate in a single ended telescopic op amp?

Status
Not open for further replies.
F

firsttimedesigning

Full Member level 1
Joined
Jul 4, 2007
Messages
97
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
2,241
Does anyone know how to alleviate the effect of slew rate in a single ended telescopic op amp(please see
)?

So far i know i can use coupling transistors but i am not sure where to put them.
 

Re: Slew Rate

slew rate can be improved by increasing the output current capacity of the amplifier or decreasing the load capacitor....
 

Re: Slew Rate

Or you can improve slew rate performance by reducing the line loss in long cables. This is affected both by the DC loop loss, as well as frequency-dependant losses caused by skin effect in the cable.

Using an equalizer can help to restore lost high frequencies, in digital or analog signal transmission. There are lots of new ideas in this area... check out National Semiconductor's "Analog Design Show" for some ideas, or look at some of the line equalizer products from Intersil.
 

Re: Slew Rate

A.Anand Srinivasan said:
slew rate can be improved by increasing the output current capacity of the amplifier or decreasing the load capacitor....
Click to expand...

i think the tail current source in important, too.
 

Re: Slew Rate

i think the tail current source in important, too.
Click to expand...

yes of course... we can increase output current by increasing tail current only....[/quote]
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…