Hi Coolman
You first need to convert all your wav files to 8-bit 11025Khz.
You can use 22050Khz for better quality.
Then open them in your favourite hex editor.
Remove the header,which is approximately everything to 1FF.
Remove the last 1FF bytes as well.
Save each file as .bin
When you have finished converting all your wav's,make one .bin file,noting the start and end addresses of each sound.
Program this .bin file into an eprom which is obviously large enough to accomodate the .bin
Use a micro to clock the eprom at the bitrate you converted your wav's to.
Convert the output of the eprom to analog using an r2r resistor network.
Use 1% resistors for the r2r-network.
Good luck
Raticus