y99lx
Member level 1
HFSS problem:
When I am using the HFSS v11, one error occurs and I cannot assign port.
The error information:
No conductors were found on port, so auto assignment of conductors on that port cannot proceed.
In the model, I use Vacuum and do some operations like "unite", "subtract", and thus there should be conductors since the boundaries are pec. Also, I define some parameters. Somebody seems saying that due to the definition of parameters in the model, the above problem occurs.
How to solve this problem. I have nearly ten parameters in the model. I don't want to remove them.
Waiting the resolution online.
Thanks.
When I am using the HFSS v11, one error occurs and I cannot assign port.
The error information:
No conductors were found on port, so auto assignment of conductors on that port cannot proceed.
In the model, I use Vacuum and do some operations like "unite", "subtract", and thus there should be conductors since the boundaries are pec. Also, I define some parameters. Somebody seems saying that due to the definition of parameters in the model, the above problem occurs.
How to solve this problem. I have nearly ten parameters in the model. I don't want to remove them.
Waiting the resolution online.
Thanks.