Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how gain remain same in mixer using current bleeding

Status
Not open for further replies.

jignesh_prajapati

Junior Member level 3
Joined
Nov 22, 2014
Messages
29
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
168
hi

i have designed mixer using current bleeding. in this method we are decreasing current through LO stage to decrease noise by directly injecting current in to RF stage , but this will also reduce current of load resistor than how gain increases because gain = 2/Pi (gm.RL) please explain anybody have idea about it
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top