Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] How far from the device can I place my bulk capacitor?

Status
Not open for further replies.

lizsagzki

Newbie level 3
Joined
Jul 18, 2014
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
29
If I have a propagation delay of 150ps/inch, where should I place my bulk capacitor (with respect to the device) that has a resonant frequency of 6MHz?
 

If we calculate wavelength of the capacitor's resonant frequency it is close to 1111 inches. There are different thumb rules like 0.005*Lamda or 0.1*lamda......
But this is not depending up on just capacitor's properties....IT depends on How it is connected to the circuit(Channel connected between Load and Decoupling capacitor and it's effectiveness), what is stack up etc.
It involves lots of equations as mentioned in
http://www.sigrity.com/papers/epep2001/web_decouplingRadius_final.pdf

Generally Bulk capacitors will be used either for filling lower value capacitor's(0.01uf,0.1uf..etc) charge during non-Transition period or to respond to big low frequency transients.
generally 1 or 2 inches from surrounding Chip is good estimate.

I recommend to follow manufacturer's recommendations.
refer
http://www.freelists.org/post/si-list/Effective-Radius-of-Decoupling-Capacitor
http://www.sigrity.com/papers/epep2001/web_decouplingRadius_final.pdf
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top