Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How does this circuit works?

Status
Not open for further replies.
this is a charger for bat.
and there is a feed back circuit.
 

It is LDO. The output voltage should be not higher than 7.5V.
If output voltage will be driven by PNP to higher voltage than 7.5V the D606 will take current of Q603 and as a result Q604 driving capability will lowered.
D605 is a short current protection. If output will be shorted to GND this diode will switch off Q603 and Q604.
 

    skjian

    Points: 2
    Helpful Answer Positive Rating
This circuit is nothing but a series voltage regulator.
 

dc to dc power supply converter&regulator
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top