Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How does a tank circuit work?

Status
Not open for further replies.

crazzy

Newbie level 4
Joined
Jun 2, 2005
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,329
Tank Circuit Work

How does a tank circuit ie., a combination of inductor and a capacitor works
 

Tank Circuit Work

the tank circuit is a filter that resonate at the frequency of thank and impedance of it is very high. at the other freqoency the impedance is very low and reject signal through the dround( or vcc).
tank circuit is a tunable circuit so that is very papular in the rf circuit for maximum gain or minium noise , ..
 

    crazzy

    Points: 2
    Helpful Answer Positive Rating
Re: Tank Circuit Work

tank circuit has two form,

one is series tank circuit, another is parallel tank circuit.

both two tank circuit's resonance frequency is 1/(2 * PI * (L * C) ^^ 1/2)

for the series tank circuit, when the driving signal's frequency is equal

to circuit's resonance frequency, the tank circuit's impedance is minimum.

for the parallel tank circuit, when the driving signal's frequency is equal

to circuit's resonance frequency, the tank circuit's impedance is maximum.

so tank circuit generally is used for selecting wanted frequency in narrow band

communication circuit.


best regards







crazzy said:
How does a tank circuit ie., a combination of inductor and a capacitor works
 

    crazzy

    Points: 2
    Helpful Answer Positive Rating
Tank Circuit Work

consider an ideal capacitor and inductor(no energy is lost) connected in parallel. when a dc source is momentarily placed across the combination,the capacitor is charged while the inductor stores no energy. when the DC SOURCE IS REMOVED, the energy stored in the capacitor transfers to the inductor (creating the positive half cycle of a sine wave). then after all the energy has been transferd to the inductor, the inductor now supplies its energy to the capacitor (the negative half cycle of a sine wave). since the components are ideal, the process goes on continuously. but practical components dissipate energy making the sine wave damped or decrease exponentially to 0.

hope i have explained it clearly
 

Re: Tank Circuit Work

well you can imagine of a paasive ,easy to build but not so high Q and a bit poor selectivity Bandpass Filter.

good luck
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top