Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How can we auto-route the design making it single sided?

Status
Not open for further replies.

zahidkhan

Member level 2
Joined
Aug 5, 2004
Messages
53
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
439
how can we auto route confining the design to be single sided.
 

mayu_wakui

Advanced Member level 4
Joined
Feb 18, 2004
Messages
117
Helped
9
Reputation
18
Reaction score
2
Trophy points
1,298
Activity points
967
Re: autorouting

depends on what software ur using, most u could specify which layers u wana route. example, in protel u could set this in the design rules. in orcad layout u go to layers manager. happy routing then..
 

cyberrat

Advanced Member level 3
Joined
Jun 19, 2001
Messages
898
Helped
86
Reputation
172
Reaction score
41
Trophy points
1,308
Location
In the sewers of the U.K.
Activity points
5,824
autorouting

As Mayu says, it's all dependant upon the auto router you want to use.

Just turn off the unwanted layers, stop it using via's etc.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top