Hi,
I am new to this group.
I am designing a telescopic cascode compensation opamp with N-Mos as i/p transistors.
I am doing the design in SPICE.
I am getting problem with the CMFB circuit.
How can I do simulation of CMFB circuit using SPICE?
Is there any material for the designing procedure!!
If so please mail it to me
Thanks In Advance
Pra
you will find a lot of examples in only 2 books
"analog cmos design " allen & holberg
"analog circuit design " Chung Yu Wu
on edaboard forum you can find a lot ok books about analogic ic design
Thanks
while simulating it in the spice, some of the transistors are going in to linear region.
Is there any commands in spice to varry the bias voltages for making all transistors in the saturation region!!!
I designed a similar OTA from about a year using spice also. It was fully differential so I needed also a CMFB. It worked me well. When I connected the whole circuit the CMFB worked and it adjusted the dc level of the output nodes as excatly I calculated it.
I think there is no such command in spice. Only sweep the dc bias until u get all transistors in saturation.
i recommend you the book called Design of Analog CMOS circuits by Behzad Razavi. You can find all about analog CMOS IC design there. Fınd it and you will have no problems about OTA and opamps
SPICE is nothing more than a similation program (i.e. differential equations solver). Do not expect black magic from it It is only YOU who make the design, not your EDA tools...