Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Just crate the PCB layout using software like Proteus PCB123 etc
and tale the print on a magazine paper.
and stick the paper on the PCB .
then press by using iron-box a
after put it in to the water finally put it into ferric chloride
this is only the step
you search the Home made PCB on you-tube ,or related video you get the tutorial video
What do you by means by "creating" ?
If refers to design there are a lot of programs ( Kicad / Protel / PADS ) to perfor that.
However if the question is to build the board there are some steps to perform cuper corrosion beyond circuit mask.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
