Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What do u mean? I guess u need how to know how to draw it and simulate it, don't you? The easiest way to do it is to create the pyramidal structure by using polylines. I designed some horns in the past. If u are interested on it I can upload a sample file.
Should you need equations to design ur horn u can find them in 'Antenna Theory' book by C. Balanis (I seem it is chapter 11, but I'm not sure). Let me know if this is enough or u need the sample file.
i want to design wideband pyramidal horn antenna in hfss, and i have done calculations of waveguide and flared part but dont know how to make it, if u anyone can help me kindly mail me on my id
spectrum6115@hotmail. or at yahoo with same id
plz help me as soon as possible.
i want to design it in the range of 1Ghz to 3Ghz, here are parameters with 15dB gain and cutoff frequency of 0.95Ghz,
a = 15.789cm (one dimension of waveguide)
b = 7.8945cm (2nd dimension of waveguide)
a1 = 39cm (dimension of horn surface)
b1 = 28.371cm (dimension of horn surface)
length of horn surface = 16.44cm
length of waveguide = 8.494cm
i calculate all these with the help of design procedure given in Balanis's book, and calculation of waveguide from David A.Pozar. i will wait for your reply, i need any modal of wide band horn antenna in HFSS working over any range. so that i may get help regarding design.
i am attaching a file kindly check it too. although it seems very good, but problem with it is, that it does not start from zero , kindly comment over it too.
i have done it, no thanx to anyone, couze nobody help me. i myself have to make it. if anybody want any help regarding horn antenn, he can contact me through my email id.
Hi Kamran,
The Broadband antenna you want to design is not simple horn.
You need to add ridges in the waveguide & horn section to increase your bandwidth.
Search for Double or quadridged horn design in search engines.
You will get many papers or references.
If you stuck at any point then you can send me personal messege.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.