Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] High Speed CMOS Rail-to-Rail IO OpAmp Design and Simulation in Cadence IC 6.1.3

Status
Not open for further replies.

htetlinnaung

Newbie level 5
Joined
Apr 14, 2009
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,395
Dear all members and analog IC designers..

I am student attending final course, now I am using Cadence IC and want to
simulate to design rail-to-rail OpAmp using design kit gpdk045 (45nm) .I want to
simulate the OpAmp from the following articles.First of all I want to simulate
the input stage .My target design is as follow:
Open Loop Gain >100db
UGB 250MHz
Input offset voltage is < 10mV
input noise voltage 10nV/sq rt Hz
SR 100V/us
total current consumption < 1mA
For input stage:
NMOS and PMOS of gpdk045 kit has Vth 0.36V and -0.4V respectively.
My question are:
1. how much I choose tail current I0 for my target (10% of total current is good ,?
2.What should I simulate test ckt PMOS and NMOS for sizing W/L ?
(eg. Id vs Vgs ,Id vs With ,Id vs Vds ?)
3. minimum channel length is 45 nm ,so what I should choose the minimum length for my design ( 2-5 times of minimum channel length is good for design?)
4.how can i plot gm vs Vcm for my input stage in Cadence?
5.In articles tell that current through M9 is replica of the M4 current. What means this ? I (M9) = I (1/(M4))?
5.If you know step procedure for designing well ,Please advice me how should I simulate to get the target design.
7.If there is anything that I should know and read for my design ,please advice me and guide me .
Thanks my dear all members .
1LxfX.png

acI8j.png
 

Attachments

  • ivanov2002.pdf
    233.9 KB · Views: 181

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top